Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FRONT OIL PUMP ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.



2. INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY


  1. Inspect the body clearance.



      C138509
    1. Push the driven gear to one side of the body.

    2. Using a feeler gauge, measure the body clearance.

      Standard clearance:
      0.075 to 0.145 mm (0.00296 to 0.00570 in.)

      Maximum clearance:
      0.145 mm (0.00570 in.)

      If the clearance is more than the maximum, replace the drive gear, driven gear or front oil pump and gear body sub-assembly.



  1. Inspect the side clearance.



      C138511
    1. Using a straightedge and feeler gauge, measure the side clearance of both gears.

      Standard side clearance:
      0.025 to 0.040 mm (0.000985 to 0.00157 in.)

      Maximum side clearance:
      0.04 mm (0.00157 in.)

      If the clearance is more than the maximum, replace the drive gear, driven gear or front oil pump and gear body sub-assembly.

      HINT:
      There are 5 different thicknesses for the drive and driven gears.
      Drive Gear Thickness 
      Mark
      Thickness [mm (in.)]
      1
      11.547 to 11.555 (0.45461 to 0.45492)
      2
      11.555 to 11.563 (0.45493 to 0.45523)
      3
      11.564 to 11.571 (0.45528 to 0.45555)
      4
      11.572 to 11.579 (0.45559 to 0.45586)
      5
      11.580 to 11.587 (0.45591 to 0.45618)
      Driven Gear Thickness 
      Mark
      Thickness [mm (in.)]
      1
      11.547 to 11.555 (0.45461 to 0.45492)
      2
      11.555 to 11.563 (0.45493 to 0.45523)
      3
      11.564 to 11.571 (0.45528 to 0.45555)
      4
      11.572 to 11.579 (0.45559 to 0.45586)
      5
      11.580 to 11.587 (0.45591 to 0.45618)



3. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


    C138514
  1. Using a caliper gauge, measure the inside diameter of the front oil pump body bushing.

    Standard inside diameter:
    43.135 to 43.160 mm (1.6983 to 1.6992 in.)

    Maximum inside diameter:
    43.160 mm (1.6992 in.)

    If the inside diameter is more than the maximum, replace the front oil pump and gear body sub-assembly.



4. INSPECT STATOR SHAFT ASSEMBLY


    C138513
  1. Using a caliper gauge, measure the inside diameter of the stator shaft bushing.

    Standard inside diameter:
    22.500 to 22.526 mm (0.88583 to 0.88684 in.)

    Maximum inside diameter:
    22.570 mm (0.88858 in.)

    If the inside diameter is more than the maximum, replace the stator shaft assembly.