DTC C1552 PIG Power Supply Voltage Malfunction |
DTC C1554 Power Supply Relay Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1552 | PIG power source circuit malfunction |
|
| C1554 | Power source relay circuit malfunction |
|

| 1.CHECK CONNECTOR CONNECTION CONDITION |
Check the connection condition of the ECU wire sub-assembly and power steering ECU assembly connectors.
Check that the ground wire is securely installed with the bolt .
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "PIG Power Supply" in the Data List and read the value displayed on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PIG Power Supply | PIG power supply/ Min.: 0.0000 V Max.: 20.1531 V | 9 to 16 V | Always |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BATTERY - ECU WIRE SUB-ASSEMBLY) |
![]() |
Disconnect the Ij1 connector from the ECU wire sub-assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Ij1-1 (PIG) - Body ground | Always | 9 to 16 V |
| *a | Front view of wire harness connector (to ECU Wire Sub-assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the j2 connector from the power steering ECU assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| j2-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 5.CHECK ECU WIRE SUB-ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| j2-1 (PIG) - Ij1-1 (PIG) | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Steering ECU Assembly) |
| *b | Front view of wire harness connector (to Vehicle Wire Harness) |
|
| ||||
| OK | ||
| ||