Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2313    Glass Position Initialization Incomplete

for Preparation Click here


DESCRIPTION

The power window regulator motor assembly is operated by the multiplex network master switch or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions.
When the ECU determines that the power window regulator motor assembly has not been initialized, DTC B2313 is stored.

D-Door Motor (Power Window Regulator Motor Assembly (for Driver Door)) 
DTC No.
DTC Detection Condition
Trouble Area
B2313
  1. Power window regulator motor assembly not initialized
  2. Power window regulator motor assembly malfunctions
  3. Battery disconnected when ignition switch ON
  1. Power window regulator motor assembly (for driver door) not initialized
  2. Power window regulator motor assembly (for driver door)

P-Door Motor (Power Window Regulator Motor Assembly (for Front Passenger Door)) 
DTC No.
DTC Detection Condition
Trouble Area
B2313
  1. Power window regulator motor assembly not initialized
  2. Power window regulator motor assembly malfunctions
  3. Battery disconnected when ignition switch ON
  1. Power window regulator motor assembly (for front passenger door) not initialized
  2. Power window regulator motor assembly (for front passenger door)

RL-Door Motor (Power Window Regulator Motor Assembly (for Rear LH Door)) 
DTC No.
DTC Detection Condition
Trouble Area
B2313
  1. Power window regulator motor assembly not initialized
  2. Power window regulator motor assembly malfunctions
  3. Battery disconnected when ignition switch ON
  1. Power window regulator motor assembly (for rear LH door) not initialized
  2. Power window regulator motor assembly (for rear LH door)

RR-Door Motor (Power Window Regulator Motor Assembly (for Rear RH Door)) 
DTC No.
DTC Detection Condition
Trouble Area
B2313
  1. Power window regulator motor assembly not initialized
  2. Power window regulator motor assembly malfunctions
  3. Battery disconnected when ignition switch ON
  1. Power window regulator motor assembly (for rear RH door) not initialized
  2. Power window regulator motor assembly (for rear RH door)

INSPECTION PROCEDURE

NOTICE:
  1. DTC B2313 can be stored in each power window regulator motor assembly (power window ECU).
  2. When disconnecting the battery while the ignition switch is ON, DTC B2313 is stored.
  3. If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (Click here).

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Turn the ignition switch to ON.

  1. Initialize the power window regulator motor assembly (Click here).

    HINT:
    Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.


NEXT


2.CHECK DTC OUTPUT
  1. Turn the ignition switch off.

  1. Wait for at least 10 seconds, and then turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    HINT:
    Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

    OK:
    DTC B2313 is not output.

    Result:
    Result
    Proceed to
    OK
    A
    NG (Driver door power window)
    B
    NG (Front passenger door power window)
    B
    NG (Rear LH door power window)
    C
    NG (Rear RH door power window)
    C



B
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR) (Click here)

C
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR) (Click here)
A

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)