Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FE)

COMPRESSOR (for 2GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)


    E167398E42
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-1 (SSR+)- E73-2 (SSR-)
    20°C (68°F)
    160 to 320 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Compressor Assembly (A/C Lock Sensor))
    If the resistance is not as specified, replace the cooler compressor assembly.



2. INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)


    E229635E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-1 (SOL-) - E74-2 (SOL+)
    20°C (68°F)
    10 to 11 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Compressor Assembly (Compressor Solenoid))
    If the resistance is not as specified, replace the cooler compressor assembly.



3. INSPECT COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the E73 cooler compressor assembly connector.



    E228787E03
  1. Disconnect the a2 magnetic clutch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-3 (MG+) - a2-1
    Always
    Below 1 Ω
    E73-3 (MG+) - Body ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the cooler compressor assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Compressor Assembly)
    *b
    Component without harness connected
    (Magnetic Clutch Assembly)