Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ACCELERATOR PEDAL SENSOR ASSEMBLY
  1. Measure the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

    5. Read the value displayed on the tester.

      Standard Voltage:
      Accelerator Pedal Operation
      Accel Sensor Out No. 1
      Accel Sensor Out No. 2
      Fully Release
      0.5 to 1.1 V
      1.2 to 2.0 V
      Fully Depressed
      2.6 to 4.5 V
      3.4 to 4.98 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.