Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › TCM

TCM > REMOVAL

for Preparation Click here


NOTICE:
If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary (Click here).



1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



4. REMOVE INLET NO. 2 AIR CLEANER


    A255421
  1. Disconnect the 2 wire harness clamps and vacuum hose clamp.

  1. Remove the 2 bolts and inlet No. 2 air cleaner.



5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A254996
  1. Disconnect the mass air flow meter connector and wire harness clamp.



    A254997
  1. Disconnect the 3 hoses.

  1. Separate the ventilation hose.



    A254998
  1. Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

  1. Release the 2 clamps and remove the air cleaner cap with hose.



6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A255892
  1. Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

  1. Remove the 2 bolts and air cleaner case sub-assembly.



8. REMOVE BATTERY


    A256224
  1. Disconnect the positive (+) cable from the positive (+) battery terminal.

  1. Loosen the nut and remove the bolt.

  1. Remove the battery and battery tray.



9. REMOVE INLET NO. 1 AIR CLEANER


    A256225
  1. Disengage the pin and remove the inlet No. 1 air cleaner.



10. REMOVE TCM


    C239666
  1. Turn the lock lever and disconnect the connector from the TCM.



    C241670
  1. Remove the 2 bolts and TCM from the automatic transaxle assembly.