Home › General › SPECIFICATIONS › 2AR-FE STARTING

2AR-FE STARTING > SERVICE DATA



Starter assembly
Standard current: 90 A or less at 11.5 V
Starter magnetic switch assembly
for 1.6 kW Type
Standard resistance
50 - C: Below 1 Ω
50 - Body: Below 2 Ω
Repair service starter kit
for 1.7 kW Type
Standard resistance
50 - C: Below 1 Ω
50 - Body: Below 2 Ω
Starter armature assembly
Standard resistance
Segment: Below 1 Ω
Commutator - Coil core: 10 kΩ or higher
Standard length: 3.1 to 3.8 mm (0.122 to 0.149 in.)
Maximum length: 3.8 mm (0.149 in.)
Starter commutator end frame
Standard length: 4.0 to 9.0 mm (0.158 to 0.354 in.)
Minimum length: 4.0 mm (0.158 in.)
Standard resistance
Positive (+) brush - Negative (-) brush: 10 kΩ or higher
Snap ring
Maximum length: 5.0 mm (0.196 in.)
Starter relay
3 - 5: 10 kΩ or higher (when battery voltage not applied between terminals 1 and 2)
3 - 5: Below 1 Ω (when battery voltage applied between terminals 1 and 2)
Engine switch
5 (SS1) - 6 (GND) / 1 (SS2) - 6 (GND)
Specified resistance
Not pushed: 10kΩ or higher
Pushed: Below 1 Ω
Standard condition: Illuminates
Measurement condition
Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (GND)
Ignition switch
Switch Position LOCK
Between all terminals
10 kΩ or higher
Switch Position ACC
2 (ACC) - 4 (AM1)
Below 1 Ω
Switch Position ON
2 (ACC) - 4 (AM1)
1 (IG1) - 4 (AM1)
5 (AM2) - 6 (IG2)
Switch Position START
3 (ST1) - 4 (AM1)
1 (IG1) - 4 (AM1)
5 (AM2) - 6 (IG2)
5 (AM2) - 7 (ST2)