DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0657 | Throttle actuator power supply error (1 trip detection logic). | ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P0657) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the tester off.
Turn the engine switch off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Wait 10 seconds or more.
Turn the engine switch off.
Wait 15 seconds or more.
Connect the tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0657 is output | B |
|
| ||||
| A | ||
| ||