DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0657 | A throttle actuator power supply error (1 trip detection logic). | ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P0657) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the tester off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Wait 10 seconds or more.
Turn the ignition switch off.
Wait 15 seconds or more.
Connect the tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0657 is output | B |
|
| ||||
| A | ||
| ||