AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > INITIALIZATION |
| 1.PREPARE VEHICLE FOR INITIALIZATION |
Unload the trunk and vehicle, ensuring that the spare tire, tools and jack are in their original positions.
Check that there are no occupants in the vehicle.
Turn off the headlights.
Stop the vehicle on a level surface and keep the vehicle height unchanged.
| |||||
| 2.CHECK HEADLIGHT LEVELING INDICATOR LIGHT |
Turn the ignition switch to ON, and check the indicator light.
| Condition | Specified Condition |
| The headlight leveling ECU assembly has been replaced with a new one. | Indicator light repeatedly blinks 6 times at 2 Hz. |
| Replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, replacement of the suspension, etc. have been performed. | Indicator light comes on for approximately 3 seconds, and then goes off (bulb check function). |
|
| ||||
| |||||
| 3.INITIALIZATION |
![]() |
Connect SST to terminals 4 (CG) and 8 (LVL) of the DLC3.
![]() |
Turn the low beam headlights on and off using the light control switch within 20 seconds after connecting the terminals.
| Fuel Level | Number of Times to Turn Low Beam Headlights On and Off |
| Fuel level is within A range. | 1 |
| Fuel level is within B range. | 2 |
| Fuel level is within C range. | 3 |
| Fuel level is within D range. | 4 |
| Fuel level is within E range. | 5 |
Check the indicator light.
| Condition | Specified Condition |
| The headlight leveling ECU assembly has been replaced with a new one. | Blinks 6 times at 2 Hz → Repeatedly blinks N*1 times at 2 Hz. |
| Replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, replacement of the suspension, etc. have been performed. | Off → Repeatedly blinks N*1 times at 2 Hz. |
|
| ||||
|
| ||||
|---|---|---|---|---|---|