DTC B2799 Engine Immobiliser System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2799 | One of the following conditions is met:
|
|
| for 2AR-FE |

| for 1AZ-FE |

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.RE-REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID.
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK CONNECTION OF CONNECTOR |
Turn the ignition switch off.
Check that the connectors are properly connected to the ECM and transponder key ECU assembly.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
Disconnect the transponder key ECU assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-12 (EFII) - A25-29 (IMO) | Always | Below 1 Ω |
| I19-13 (EFIO) - A25-28 (IMI) | Always | Below 1 Ω |
| I19-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| I19-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| A25-29 (IMO) - Body ground | Always | 10 kΩ or higher |
| A25-28 (IMI) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| I19-12 (EFII) - A74-10 (IMO) | Always | Below 1 Ω |
| I19-13 (EFIO) - A74-11 (IMI) | Always | Below 1 Ω |
| I19-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| I19-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| A74-10 (IMO) - Body ground | Always | 10 kΩ or higher |
| A74-11 (IMI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.REPLACE ECM |
Replace the ECM (Click herefor 2AR-FE, Click here for 1AZ-FE).
| NEXT | |
| 7.REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID.
| NEXT | |
| 8.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||