Home › Engine / Hybrid System ยท 2AR-FE › INTAKE / EXHAUST › INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) > INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)


  1. Check the intake air control valve actuator operation.



      A197176E05
    1. Check that the motor operates when the battery is connected to the terminals of the intake air control valve actuator.

      NOTICE:
      Apply battery voltage for 1 to 3 seconds.
      If battery voltage is applied for more than 3 seconds, the actuator may be damaged.
      If the positive (+) and negative (-) battery leads contact the sensor terminals, the actuator may be damaged.

      Standard:
      Tester Connection
      Specified Condition
      Positive (+) battery voltage applied to terminal 4 (M-), and negative (-) battery voltage applied to terminal 5 (M+)
      Motor rotates clockwise
      Positive (+) battery voltage applied to terminal 5 (M+), and negative (-) battery voltage applied to terminal 4 (M-)
      Motor rotates counterclockwise

      If the result is not as specified, replace the intake air control valve actuator.