Home › Engine / Hybrid System ยท 1AZ-FE › INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


3. REMOVE ENGINE UNDER COVER LH


4. REMOVE ENGINE UNDER COVER RH


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A266362
  1. Disconnect the oxygen sensor connector.



    A254747
  1. Remove the 2 bolts, 2 nuts, 2 compression springs and front exhaust pipe assembly.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold converter sub-assembly.



6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A112189
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator.



7. REMOVE AIR FUEL RATIO SENSOR


    A264440
  1. Remove the hose clamp.

  1. Disconnect the air fuel ratio sensor connector.



    A264432E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

    SST
    09224-00010  



8. REMOVE MANIFOLD STAY


    A112193
  1. Remove the bolt, nut and manifold stay.



9. REMOVE NO. 2 MANIFOLD STAY


    A112192
  1. Remove the bolt, nut and No. 2 manifold stay.



10. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    A195979
  1. Using a 12 mm deep socket wrench, remove the 5 nuts and exhaust manifold converter sub-assembly.



    A193120
  1. Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.



11. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A179080
  1. Remove the 2 bolts and No. 2 exhaust manifold heat insulator.



12. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    A211653
  1. Remove the 4 bolts and No. 1 manifold converter insulator.