BRAKE PEDAL (for LHD) > INSTALLATION |
| 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY |
Install the brake pedal support assembly with the 4 nuts.
Engage the 3 clamps to install the wire harness to the brake pedal support assembly.
Connect the brake pedal load sensing switch connector and engage the clamp.
| 2. INSTALL BRAKE PEDAL RETURN SPRING |
![]() |
Install the brake pedal return spring to the brake pedal support assembly.
| 3. INSTALL PUSH ROD PIN |
![]() |
Apply lithium soap base glycol grease to the push rod pin.
![]() | Lithium Soap Base Glycol Grease |
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
| 4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER |
| 5. INSTALL STOP LIGHT SWITCH ASSEMBLY |
![]() |
Insert the stop light switch assembly until the threaded sleeve hits the pedal.
![]() |
Make a quarter turn clockwise to install the stop light switch assembly.
Connect the connector.
Check the protrusion of the plunger.
| Area | Measurement |
| a | 1.5 to 2.5 mm (0.0591 to 0.0984 in.) |
| 6. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (w/ Automatic Headlight Beam Level Control System) |
Engage the 2 guides.
Install the headlight leveling ECU assembly with the bolt.
Engage the clamp.
Connect the connector.
| 7. INSTALL AFS ECU (w/ AFS) |
Engage the 2 guides.
Install the AFS ECU with the bolt.
Engage the clamp.
Connect the connector.
| 8. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT |
| 9. INSPECT AND ADJUST BRAKE PEDAL |