Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)

BRAKE PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT
(Click here)


2. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY (w/ Automatic Headlight Beam Level Control System)


    E226686E01
  1. Disconnect the connector.

  1. Disengage the clamp.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide

  1. Remove the bolt.

  1. Disengage the 2 guides and remove the headlight leveling ECU assembly.



3. REMOVE AFS ECU (w/ AFS)


    E226686E01
  1. Disconnect the connector.

  1. Disengage the clamp.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide

  1. Remove the bolt.

  1. Disengage the 2 guides and remove the AFS ECU.



4. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E226682
  1. Disconnect the connector.



    E226683
  1. Turn the stop light switch assembly counterclockwise and remove it.



5. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


6. REMOVE PUSH ROD PIN


    C243063
  1. Remove the clip and push rod pin.

  1. Separate the brake master cylinder push rod clevis from the brake pedal support assembly.



7. REMOVE BRAKE PEDAL RETURN SPRING


    C239881
  1. Remove the brake pedal return spring from the brake pedal support assembly.



8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C239194
  1. Disconnect the brake pedal load sensing switch connector and disengage the clamp.



    C239193
  1. Disengage the 3 clamps and separate the wire harness from the brake pedal support assembly.



    C239195
  1. Remove the 4 nuts and brake pedal support assembly.