Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)

BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT

HINT:
Use the same procedure for LHD and RHD (Click here).



2. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E226682
  1. Disconnect the connector.



    E226683
  1. Turn the stop light switch assembly counterclockwise and remove it.



3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


4. REMOVE PUSH ROD PIN


    C238444
  1. Remove the clip and push rod pin.

  1. Separate the brake master cylinder push rod clevis from the brake pedal support assembly.



5. REMOVE BRAKE PEDAL RETURN SPRING


    C239882
  1. Remove the brake pedal return spring from the brake pedal support assembly.



6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C239859
  1. Disconnect the brake pedal load sensing switch connector.



    C239860
  1. Disengage the 3 clamps and separate the wire harness from the brake pedal support assembly.



    C239861
  1. Remove the 4 nuts and brake pedal support assembly.