BRAKE MASTER CYLINDER (for RHD) > REMOVAL |
| 1. DRAIN BRAKE FLUID |
| 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Disconnect the reservoir level switch connector.
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts, vacuum check valve bracket and brake master cylinder sub-assembly.
| *1 | Master Cylinder Piston |
| 5. REMOVE BRAKE MASTER CYLINDER O-RING |
Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.