Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for RHD)

BRAKE MASTER CYLINDER (for RHD) > DISASSEMBLY

for Preparation Click here



1. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY


2. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER


3. REMOVE BRAKE MASTER CYLINDER STRAIGHT PIN


    C239883
  1. Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a pin punch and a hammer, tap out the brake master cylinder straight pin from the brake master cylinder sub-assembly.

    NOTICE:
    Do not drop the brake master cylinder reservoir sub-assembly.



4. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the brake master cylinder reservoir sub-assembly from the brake master cylinder assembly.



5. REMOVE MASTER CYLINDER RESERVOIR GROMMET
  1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir sub-assembly.