Home › Power Source / Network ยท NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING THE BATTERY CABLE

NOTICE:
When disconnecting the battery negative (-) cable, initialize the following system after the cable is reconnected

System Name
See Procedure
Parking Assist Monitor System
Click here


2.PRECAUTIONS WHEN USING INTELLIGENT TESTER
  1. When using the intelligent tester to troubleshoot with the ignition switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.

  2. After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned to ON.


3.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Engine Switch (Condition)
    Ignition Switch off
    LOCK
    Off
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    Engine Start
    START
    Start