Home › Power Source / Network · NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



LIN COMMUNICATION SYSTEM DESCRIPTION
The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication because of an open in the communication lines or other reasons, the master control ECU of the relevant system will store a DTC. Refer to the table below about the communication bus lines and connected components.

HINT:
  1. Each component has a fail-safe function which activates to maintain the minimum performance of the system and protect the system.
  2. In the following table, "○" indicates that the function applies, and "-" indicates that it does not.


Door Bus Lines 
Component
Master Control
LIN Communication DTC Output Function
Main Body ECU (Multiplex Network Body ECU)
○
○
Power Window Regulator Motor Assembly (for Driver Door)
-
-
Power Window Regulator Motor Assembly (for Front Passenger Door)
-
-
Power Window Regulator Motor Assembly (for Rear LH Door)
-
-
Power Window Regulator Motor Assembly (for Rear RH Door)
-
-
Multiplex Network Master Switch Assembly
-
-
Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)*
-
-
  1. *: w/ Sliding Roof System

Certification Bus Lines (w/ Smart Entry and Start System) 
Component
Master Control
LIN Communication DTC Output Function
Certification ECU (Smart Key ECU Assembly)
○
○
Steering Lock ECU (Steering Lock Actuator Assembly)
-
-
ID Code Box (Immobiliser Code ECU)*
-
-
  1. *: w/o Wireless Door Lock Buzzer Answer Back Function