Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER

FRONT SEATBACK HEATER > INSTALLATION

for Preparation Click here



1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    B281074
  1. Using hog ring pliers, install the separate type front seatback cover to the separate type front seatback pad with 6 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
  1. Temporarily install the separate type front seatback cover with pad.

  1. Engage the 4 claws to install the 2 front seat headrest supports.

  1. Install the 2 brackets with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after installing the nut.
    3. Install the bracket securely.



    B288591
  1. Turn back the separate type front seatback cover.

  1. Using hog ring pliers, install the 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B281114
  1. Using hog ring pliers, install 3 new hog rings.

    NOTICE:
    When installing the hog rings, take care to minimize wrinkles as much as possible.



    B281111
  1. Using hog ring pliers, install 5 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



3. CONNECT CONNECTOR
  1. Engage the clamp.

  1. Connect the connector.



4. CONNECT SEPARATE TYPE FRONT SEATBACK COVER
  1. Connect the rubber band of the separate type front seatback cover.



5. INSTALL FRONT SEAT ASSEMBLY
(Click here)