FRONT SEAT CUSHION HEATER > INSTALLATION |
| 1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER |
![]() |
Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 16 new hog rings.
![]() |
Using hog ring pliers, install 2 new hog rings.
| 2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
Temporarily install the separate type front seat cushion cover with pad.
Engage each hook.
w/ Seat Heater System:
Engage the 2 clamps to install the seat heater wire harness.
Connect the connector.
Engage the clamp.
Connect the connector.
Engage the claw and 3 clamps to install the front seat airbag assembly wire harness.
Engage the fastener to secure the front seat airbag assembly wire harness.
| 3. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Driver Side) |
Engage the 5 claws and 6 guides to install the front seat inner cushion shield.
| 4. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side) |
Engage the 5 claws and 7 guides to install the front seat inner cushion shield.
| 5. INSTALL FRONT SEAT CUSHION SHIELD (for Driver Side) |
Connect the front lumbar power seat switch connector.
Connect the front power seat switch connector.
Engage the 2 wire harness clamps.
Install the wire harness to the wire harness cover.
Engage the 2 claws to close the wire harness cover.
Engage the 4 claws, 7 guides and clip to install the front seat cushion shield.
| 6. INSTALL FRONT SEAT CUSHION SHIELD (for Front Passenger Side) |
Connect the front power seat switch connector.
Engage the 2 wire harness clamps.
Install the wire harness to the wire harness cover.
Engage the 3 claws to close the wire harness cover.
Engage the 4 claws, 8 guides and clip to install the front seat cushion shield.
| 7. INSTALL NO. 1 FRONT SEAT INNER CUSHION SHIELD |
![]() |
Engage the 3 claws and 3 guides to install the front No. 1 seat inner cushion shield as shown in the illustration.
![]() |
Engage the 2 claws to install the front No. 1 seat inner cushion shield to the clip as shown in the illustration.
Install the screw.
| 8. CONNECT SEPARATE TYPE FRONT SEATBACK COVER |
Connect the rubber band of the separate type front seatback cover.
| 9. INSTALL FRONT SEAT ASSEMBLY |