Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID

BRAKE FLUID > REPLACEMENT

for Preparation Click here


NOTICE:
  1. Move the shift lever to P and apply the parking brake before replacing the brake fluid.
  2. Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.
  3. If brake fluid leaks onto any painted surface, immediately wash it off.

HINT:
If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.



1. FILL RESERVOIR WITH BRAKE FLUID


    C239885
  1. Remove the brake master cylinder reservoir filler cap.

  1. Fill the reservoir with brake fluid.

    Brake Fluid:
    SAE J1703 or FMVSS No. 116 DOT 3

    NOTICE:
    Make sure that there is sufficient brake fluid in the reservoir.



2. BLEED BRAKE LINE

NOTICE:
  1. Bleed the brake line of the wheel farthest from the master cylinder first.
  2. Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brake lines.

  1. Connect a vinyl tube to the bleeder plug.

  1. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1

  1. When fluid stops coming out, tighten the bleeder plug, and release the brake pedal.*2

  1. Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.

  1. Tighten the bleeder plug completely.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. Repeat the above steps to replace the brake fluid of the brake lines for each wheel.



3. INSPECT FOR BRAKE FLUID LEAK


4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR


    C239199E01
  1. Check the fluid level.
    Text in Illustration 
    *a
    MAX Line
    *b
    MIN Line
    If brake fluid level is lower than the MIN line, check for leaks and inspect the disc brake pads. If necessary, refill the reservoir with brake fluid to the MAX line after repair or replacement.

    Brake Fluid:
    SAE J1703 or FMVSS No. 116 DOT 3

    NOTICE:
    If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.