RAIN SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT RAIN SENSOR |
![]() |
Disconnect the S1 rain sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S1-4 (SIG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S1-2 (ES) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Rain Sensor) |
![]() |
Reconnect the rain sensor connector.
Connect an oscilloscope to the rain sensor connector.
Check for pulses.
| Tester Connection | Condition | Specified Condition |
| S1-1 (MPX) - S1-2 (ES) | Ignition switch ON | Pulse generation |
| *a | Component with harness connected (Rain Sensor) |