DTC P060A Internal Control Module Monitoring Processor Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060A | A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
| ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060A) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off and turn the tester off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the battery negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P060A is output | B |
|
| ||||
| A | ||
| ||