DTC P060B Internal Control Module A/D Processing Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060B | An ECM main CPU communication error (1 trip detection logic). |
|
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060B) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the tester off.
Turn the engine switch off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P060B is output | B |
| DTC P060B and P0327, P0328, P0332 and P0333 are output | C |
|
| ||||
|
| ||||
| A | ||
| ||