Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY
  1. Engage the 2 claws and install the unlock warning switch assembly to the steering column upper bracket.

  1. Connect the connector.



2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


3. INSPECT STEERING WHEEL CENTER POINT


4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY


    C239346E01
  1. Make sure that the ignition switch lock cylinder assembly is in the ACC position.
    Text in Illustration 
    *a
    LOCK
    *b
    ACC

  1. Install the ignition switch lock cylinder assembly to the steering column upper bracket assembly.

  1. Make sure that the ignition switch lock cylinder assembly is securely installed.



5. INSTALL TRANSPONDER KEY AMPLIFIER
  1. Connect the connector to the transponder key amplifier.



    B279927
  1. Engage the 2 claws and install the transponder key amplifier.



6. INSTALL UPPER STEERING COLUMN COVER
  1. Engage the 2 claws to install the upper steering column cover.

  1. Engage the 4 clips and 2 guides to install the instrument cluster finish panel to the upper steering column cover.



7. INSTALL LOWER STEERING COLUMN COVER

NOTICE:
If the lower steering column cover is installed in the incorrect order, it will not be possible to assemble the steering column cover.

  1. Engage the 2 claws.



    E228110
  1. Engage the 2 claws.

    HINT:
    Press the area around the claws to engage them.

  1. Turn the steering wheel assembly to the left and install the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Turn the steering wheel assembly to the right and install the lower steering column cover with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).