OIL PUMP > INSPECTION |
| 1. INSPECT OIL PUMP RELIEF VALVE |
![]() |
Coat the relief valve with engine oil and check that it falls smoothly into the valve hole by its own weight.
If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.
| 2. INSPECT OIL PUMP ROTOR SET |
![]() |
Install the rotors to the timing chain cover with the rotor marks facing up. Check that the rotors rotate smoothly.
| *a | Mark |
![]() |
Check the tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotor tips as shown in the illustration.
![]() |
Check the side clearance.
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge as shown in the illustration.
![]() |
Check the body clearance.
Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor as shown in the illustration.