DTC P1607 Cruise Control Input Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1607 | ECM CPUs malfunction (1 trip detection logic). | ECM |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | Cruise control |
| Frequency of Operation | Continuous |
| Cruise control | Forbiddance |
| Either of the following conditions is met | (a) or (b) |
| (a) Cruise control | Operating |
| (b) Low speed control | Operating |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P1607) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the engine switch off and turn the tester off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P1607 is output | B |
|
| ||||
| A | ||
| ||