Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL OIL SEAL

DIFFERENTIAL OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Using a 10 mm hexagon socket wrench, remove the drain plug and gasket, and drain the ATF.

  1. Using a 10 mm hexagon socket wrench, install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. REMOVE FRONT DRIVE SHAFT ASSEMBLY
(Click here)


3. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL


    D025835E04
  1. Using SST, remove the differential side bearing retainer oil seal.

    SST
    09308-00010  



4. REMOVE DRIVE SHAFT BEARING BRACKET


    A134945
  1. Remove the 3 bolts and drive shaft bearing bracket.



5. REMOVE TRANSAXLE HOUSING OIL SEAL


    D025827E04
  1. Using SST, remove the transaxle housing oil seal.

    SST
    09308-00010  



6. INSTALL TRANSAXLE HOUSING OIL SEAL


    C196088E01
  1. Using SST and a hammer, install a new transaxle housing oil seal.

    SST
    09316-60011   (09316-00011)

    Standard depth:
    -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

    NOTICE:
    Do not damage the oil seal lip.

  1. Coat the lip of the oil seal with MP grease.



7. INSTALL DRIVE SHAFT BEARING BRACKET
  1. Install the drive shaft bearing bracket with the 3 bolts.

    Torque:
    64 N*m{ 650 kgf*cm , 47 ft.*lbf }



8. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL


    C196089E01
  1. Using SST and a hammer, install a new differential side bearing retainer oil seal.

    SST
    09649-17010  
    09950-70010   (09951-07150)

    Standard depth:
    -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

    NOTICE:
    Do not damage the oil seal lip.

  1. Coat the lip of the oil seal with MP grease.



9. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH
  1. Install a new front drive shaft hole snap ring LH.

    NOTICE:
    Face the end gap of the front drive shaft hole snap ring downward.



10. INSTALL FRONT DRIVE SHAFT ASSEMBLY
(Click here)


11. ADD AUTOMATIC TRANSAXLE FLUID


12. INSPECT TRANSAXLE FLUID LEVEL

HINT:
Drive the vehicle so that the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80°C (158 to 176°F)



    D025120E13
  1. Park the vehicle on a level surface and apply the parking brake.
    Text in Illustration 
    *a
    OK if hot
    *b
    Add if hot

  1. With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to L. Then return it to P.

  1. Pull out the dipstick and wipe it clean.

  1. Push the dipstick back fully into the pipe.

  1. Pull the dipstick out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add a proper amount of new fluid and recheck the fluid level.

    NOTICE:
    Use Toyota Genuine ATF WS.