BRAKE ACTUATOR > INSTALLATION |
| 1. INSTALL BRAKE ACTUATOR ASSEMBLY |
![]() |
Install the brake actuator assembly to the brake actuator bracket assembly.
Tighten the 3 nuts.
| 2. INSTALL BRAKE ACTUATOR WITH BRACKET |
![]() |
Install the brake actuator with bracket to the vehicle body with the 3 bolts.
![]() |
Temporarily tighten each brake line to the correct position on the brake actuator assembly as shown in the illustration.
| *a | From 1st Chamber of Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Using a union nut wrench, fully tighten each brake line.
![]() |
Connect the brake actuator connector and disengage the claw (b).
Put the lever down and engage the claw (a) to engage the connector lock.
| 3. INSTALL SUCTION PIPE CLAMP |
Engage the suction pipe clamp to install it to the brake actuator bracket assembly.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. BLEED BRAKE SYSTEM |
| 6. INSPECT BRAKE ACTUATOR USING INTELLIGENT TESTER |
| 7. PERFORM SYSTEM VARIANT LEARNING |
| 8. CHECK FOR AND CLEAR DTCS |