BRAKE ACTUATOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. SEPARATE SUCTION PIPE CLAMP |
![]() |
Disengage the suction pipe clamp to separate it from the brake actuator bracket assembly.
| 4. REMOVE BRAKE ACTUATOR WITH BRACKET |
![]() |
Disengage the claw (a) and raise the lock lever.
Engage the claw (b) and disconnect the connector from the brake actuator assembly.
![]() |
Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
| *a | From 1st Chamber of Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Use tags or make a memo to identify the places to reconnect the lines.
![]() |
Remove the 3 bolts and brake actuator with bracket from the vehicle body.
| 5. REMOVE BRAKE ACTUATOR ASSEMBLY |
![]() |
Loosen the 3 nuts and remove the brake actuator assembly from the brake actuator bracket assembly.