Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B281851E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B281852E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
    Text in Illustration 
    *1
    Pin Hold Clip

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B281854
  1. Remove the 6 screws.



    B281855
  1. Disengage the 3 claws.

    HINT:
    Use the same procedure for the RH side and LH side.



  1. Pull back the side of the front bumper assembly as shown in the illustration and disconnect each connector.


    B281874E01


    Text in Illustration 
    *A
    except TMC Made
    *B
    for TMC Made
    *C
    w/ TOYOTA Parking Assist-sensor System
    *D
    w/ Fog Light

    NOTICE:
    Do not apply excessive force when separating the front bumper.

    HINT:
    Use the same procedure for the RH side and LH side.



    B281857
  1. Remove the 2 screws.

  1. Using a clip remover, remove the 3 clips.



  1. w/ Headlight Cleaner System:



      B282867
    1. Disconnect the headlight cleaner hose and drain the washer fluid.

      HINT:
      Use a container to collect the washer fluid.

  1. Remove the front bumper assembly.