REAR BUMPER > REMOVAL |
| 1. REMOVE REAR BUMPER PLATE LH |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws.
| *1 | Protective Tape |
| *2 | Hook |
Disengage the hook and remove the rear bumper plate LH.
| 2. REMOVE REAR BUMPER PLATE RH |
| 3. REMOVE REAR BUMPER ASSEMBLY |
![]() |
Put protective tape around the rear bumper assembly.
| *1 | Protective Tape |
![]() |
Using a clip remover, remove the 2 clips.
Remove the 6 screws.
![]() |
Remove the 2 screws.
![]() |
Disengage the 7 claws as shown in the illustration.
![]() |
Disengage the 6 claws as shown in the illustration.
w/ TOYOTA Parking Assist-sensor System:
Disconnect the connector.
Remove the rear bumper assembly.