DTC C1436 Yaw Rate Sensor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1436 | Difference between the yaw rate sensor value and the control value estimated inside the skid control ECU is abnormal. |
|
| 1.READ VALUE USING INTELLIGENT TESTER (YAW RATE AND ACCELERATION SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List using the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Yaw Rate Sensor | Yaw rate sensor / Min.: -128 °/s, Max.: 127 °/s | Vehicle stopped: 0 °/s Turning right: -128 to 0 °/s Turning left: 0 to 127 °/s | - |
Check that the yaw rate and acceleration sensor (airbag sensor assembly) output value displayed on the intelligent tester.
| Result | Proceed to |
| NG (The yaw rate and acceleration sensor (airbag sensor assembly) output value is 0 °/s when the vehicle is stationary, but the value fluctuates when turning.) | A |
| NG (The yaw rate and acceleration sensor (airbag sensor assembly) output value is not 0 °/s when the vehicle is stationary.) | B |
| OK | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Turn the ignition switch off.
Drive the vehicle straight ahead at 50 km/h (31 mph) or more for at least 30 seconds.
Check that the steering wheel is correctly centered while driving straight ahead.
|
| ||||
| OK | |
| 3.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION |
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly (Click here).
|
| ||||
| OK | ||
| ||