Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY


    A190679E11
  1. Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly shown in the illustration.
    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)

    OK:
    There is no foreign matter.



    A196153E10
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Mass Air Flow Meter Sub-assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E14-1 (THA) - E14-2 (E2)
    -20°C (-4°F)
    13.6 to 18.4 kΩ
    E14-1 (THA) - E14-2 (E2)
    20°C (68°F)
    2.21 to 2.69 kΩ
    E14-1 (THA) - E14-2 (E2)
    60°C (140°F)
    0.49 to 0.67 kΩ

    If the result is not as specified, replace the mass air flow meter sub-assembly.