ACTIVE CONTROL ENGINE MOUNT > ON-VEHICLE INSPECTION |
| 1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY |
Check the operation.
Connect the intelligent tester to DLC3.
Start the engine and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / Active Test / Control the ACM Inhibit.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the ACM Inhibit | ACM | ON / OFF | Test is possible while engine is idling |
Check if the front engine mounting insulator assembly operates in accordance with tester operation.
| Condition | Specified Condition |
| "Control the ACM Inhibit" is OFF | The engine does not move (insulator operation is normal). |
| "Control the ACM Inhibit" is ON | The engine moves in accordance with insulator operation. |
Inspect for vacuum leaks.
Disconnect the vacuum hose from the front engine mounting insulator assembly.
![]() |
Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 25 in.Hg) and wait for 1 minute.
Check that there is no change in the needle movement of the vacuum pump gauge.
Check that there is no fluid leakage caused by a break in the diaphragm.
Reconnect the vacuum hose.