Home › Engine / Hybrid System · 2GR-FE › ENGINE CONTROL › VACUUM SWITCHING VALVE (for Engine Mounting)

VACUUM SWITCHING VALVE (for Engine Mounting) > INSPECTION

for Preparation Click here



1. INSPECT DUTY VACUUM SWITCHING VALVE (OPERATION)


    A052014E04
  1. Check the operation of the duty vacuum switching valve when positive battery voltage is applied to its terminals.

    Standard Condition:
    Condition
    Specified Condition
    Battery voltage is not applied
    The air from pipe G is flowing out through pipes E and H.
    Battery voltage is applied
    The air from pipe F is flowing out through pipes E and H.

    If the result is not as specified, replace the duty vacuum switching valve.



2. INSPECT DUTY VACUUM SWITCHING VALVE (RESISTANCE)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    19 to 21 Ω

    If the resistance is not as specified, replace the duty vacuum switching valve.