POWER WINDOW CONTROL SYSTEM > Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH |

| 1.READ VALUE USING INTELLIGENT TESTER (RL-DOOR MOTOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / RL-Door Motor / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RL Door P/W Auto SW | Rear LH door power window auto switch signal / ON or OFF | ON: Rear LH power window auto switch operated OFF: Rear LH power window auto switch not operated | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION (FOR REAR LH DOOR) |
Initialize the power window regulator motor assembly (for rear LH door) (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION) |
Check that the rear LH door power window moves when the auto up and down functions of the rear power window regulator switch assembly (for LH door) are operated (Click here).
|
| ||||
| OK | ||
| ||
| 4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR) |
![]() |
Remove the rear power window regulator switch assembly (for LH door) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (AUTO) - 1 (GND) | Auto up or auto down position | Below 1 Ω |
| *a | Component without harness connected (Rear Power Window Regulator Switch Assembly (for LH Door)) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH (FOR LH DOOR) - WINDOW REGULATOR MOTOR (FOR REAR LH DOOR)) |
Disconnect the power window regulator motor assembly (for rear LH door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M4-8 (AUTO) - M2-4 (AUTO) | Always | Below 1 Ω |
| M4-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| M2-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||