DTC P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0503 | A momentary interruption or noise is detected when a rapid change of the vehicle speed occurs while the cruise control system is controlling vehicle speed. |
|

| 1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly (Click here).
| NEXT | |
| 3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM) |
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control switch (ON-OFF button).
Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC P0503 is output (for 2AR-FE) | B |
| DTC P0503 is output (for 2GR-FE) | C |
|
| ||||
|
| ||||
| A | ||
| ||