Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0503    Vehicle Speed Sensor "A" Intermittent / Erratic / High

for Preparation Click here


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is controlling vehicle speed, the ECM determines that there is a momentary interruption or noise, and stores a DTC.

DTC No.
DTC Detection Condition
Trouble Area
P0503
A momentary interruption or noise is detected when a rapid change of the vehicle speed occurs while the cruise control system is controlling vehicle speed.
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. Combination meter assembly
  4. ECM

WIRING DIAGRAM


E238915E05


INSPECTION PROCEDURE

This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.
1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) (Click here)
A


2.REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly (Click here).


NEXT


3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control operation is possible.

    2. Turn the cruise control system on using the cruise control switch (ON-OFF button).

    3. Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P0503 is output (for 2AR-FE)
    B
    DTC P0503 is output (for 2GR-FE)
    C
    DTC P0503 is output (for 1AZ-FE)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

END (COMBINATION METER ASSEMBLY WAS DEFECTIVE)