Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E227514
  1. Extend the headlight washer washer nozzle sub-assembly.

  1. Disengage the 2 claws and remove the headlight washer washer nozzle sub-assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



2. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E227511
  1. Slide the clip and disconnect the headlight cleaner hose.



    E227510
  1. Remove the bolt.



  1. Push the tab (A) and disengage the claw and remove the headlight washer actuator sub-assembly as shown in the illustration.


    E227512E01

    HINT:
    Use the same procedure for the RH side and LH side.



4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



5. REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)


    B281860
  1. Disengage the 5 clamps and remove the headlight cleaner hose.



6. REMOVE NO. 4 ENGINE ROOM WIRE (for TMC Made)


  1. w/ Fog Light without TOYOTA Parking Assist-sensor System:



      B281872
    1. Disconnect the connector.

    2. Disengage the clamp and remove the No.4 engine room wire.

      HINT:
      Use the same procedure for the RH side and LH side.



  1. w/ Fog Light and TOYOTA Parking Assist-sensor System:



      B281873
    1. Disconnect the 2 connectors.

    2. Disengage the clamp and remove the No.4 engine room wire.

      HINT:
      Use the same procedure for the RH side and LH side.



7. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)


  1. for TMC Made:



      E228021E01
    1. Disconnect the connector.
      Text in Illustration 
      *A
      LH Side
      *B
      RH Side



    E228019E01
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
    Text in Illustration 
    *A
    LH Side
    *B
    RH Side



8. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)


    E228020E01
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the front bumper assembly.
    Text in Illustration 
    *A
    LH Side
    *B
    RH Side



9. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
  1. for TMC Made:

    1. Disconnect the connector.



    E226759
  1. Remove the screw.

  1. Disengage the 2 guides and remove the fog light assembly.



10. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure as for the LH side.



11. REMOVE FRONT FENDER LINER RETAINER


    B281861
  1. Disengage the claw and remove the front fender liner retainer.

    HINT:
    Use the same procedure for the RH side and LH side.



12. REMOVE RADIATOR GRILLE SUB-ASSEMBLY


    B281862
  1. Disengage the 10 claws and remove the radiator grille sub-assembly.



13. REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY


    B281870
  1. Disengage the 3 claws and guide to remove the radiator grille emblem assembly.



14. REMOVE NO. 1 LOWER RADIATOR GRILLE


    B281863
  1. Disengage the 18 claws and remove the No. 1 lower radiator grille.



15. REMOVE FRONT BUMPER HOLE COVER LH


    B281864
  1. Remove the screw.

  1. Disengage the 4 claws and remove the front bumper hole cover LH.



16. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedure as for the LH side.



17. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET


    B281865
  1. Remove the 2 screws.

  1. Disengage the 2 claws and remove the front bumper extension mounting bracket.



18. REMOVE LOWER FRONT BUMPER COVER


    B281866E01
  1. Disengage the 2 claws.
    Text in Illustration 
    *1
    Hook

  1. Disengage the hook and remove the lower front bumper cover.



19. REMOVE FRONT BUMPER ENERGY ABSORBER


    B281858
  1. Disengage the 2 guides and remove the front bumper energy absorber.



20. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B281859
  1. Disengage the 5 clamps.

  1. Remove the 6 bolts and front bumper reinforcement sub-assembly.



21. REMOVE FRONT BUMPER SIDE RETAINER LH


    B281875
  1. Remove the bolt and screw.

  1. Disengage the 2 claws and remove the front bumper side retainer LH.



22. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.