Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for LHD)
  1. Engage the 2 claws to install the back sonar or clearance sonar switch assembly.



2. INSTALL BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for RHD)
  1. Engage the 2 claws to install the back sonar or clearance sonar switch assembly.



3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B280330
  1. Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

  1. Connect each connector.

  1. for LHD:

    1. Engage the 3 claws, 7 clips and 4 guides.

  1. for RHD:

    1. Engage the 4 claws, 5 clips and 4 guides.



    B283375
  1. Engage the 4 clips and 2 guides to install the instrument cluster finish panel assembly.



4. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B280325
  1. Engage the 4 clips to install the No. 1 instrument panel register assembly.



5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
  1. w/ Smart Entry and Start System:

    1. Connect the connector.



    B281783
  1. Engage the 2 claws and 4 clips to install the upper instrument panel finish panel.



6. INSTALL INSTRUMENT SIDE PANEL
  1. Engage the 3 guides.



    B280321
  1. Engage the 4 claws to install the instrument side panel LH as shown in the illustration.



7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LHD:
for RHD:


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



9. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

NOTICE:
Reset the auto away/return function setting to the previous condition by changing the customize parameter (Click here).