Home › Drivetrain · U241E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SHIFT SOLENOID VALVE (SLT, SL1, SL2)


    C223173E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    5.0 to 5.6 Ω

    Text in Illustration 
    *a
    Component without harness connected
    Shift Solenoid Valve (SLT, SL1, SL2)
    If the value is not as specified, replace the shift solenoid valve.

  1. Connect a positive (+) battery lead with a 21 W bulb to terminal 2 and a negative (-) battery lead to terminal 1 of the solenoid valve connector, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The solenoid makes an operating sound.

    If the operation cannot be done as specified, replace the shift solenoid valve.



2. INSPECT SHIFT SOLENOID VALVE DSL


    A112706E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Solenoid Connector (DSL) - Solenoid Body (DSL)
    20°C (68°F)
    11 to 13 Ω

    Text in Illustration 
    *a
    Shift Solenoid Valve DSL
    If the value is not as specified, replace the shift solenoid valve DSL.

  1. Connect a positive (+) battery lead to the terminal of the solenoid connector, and a negative (-) battery lead to the solenoid body, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The solenoid makes an operating sound.

    If the operation cannot be done as specified, replace the shift solenoid valve DSL.



3. INSPECT SHIFT SOLENOID VALVE S4


    G028386E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Solenoid Connector (S4) - Solenoid Body (S4)
    20°C (68°F)
    11 to 15 Ω

    Text in Illustration 
    *a
    Shift Solenoid Valve S4
    If the value is not as specified, replace the shift solenoid valve S4.

  1. Connect a positive (+) battery lead to the terminal of the solenoid connector, and a negative (-) battery lead to the solenoid body, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The solenoid makes an operating sound.

    If the operation cannot be done as specified, replace the shift solenoid valve S4.