Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT V-RIBBED BELT


    A058797E08
  1. Check the belt for wear, cracks or other signs of damage.
    Text in Illustration 
    *a
    INCORRECT
    If any of the following defects is found, replace the V-ribbed belt.

    1. The belt is cracked.
    2. The belt is worn out to the extent that the cords are exposed.
    3. The belt has chunks missing from the ribs.



    A087787E18
  1. Check that the belt fits properly in the ribbed grooves.
    Text in Illustration 
    *a
    CORRECT
    *b
    INCORRECT

    HINT:
    Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed. Install a new V-ribbed correctly.