ROOM TEMPERATURE SENSOR > REMOVAL |
| 1. PRECAUTION (for RHD with Smart Entry and Start System) |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System) |
| 3. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 6. REMOVE INSTRUMENT SIDE PANEL |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 7. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD) |
![]() |
Disengage the 2 claws and 4 clips to remove the upper instrument panel finish panel as shown in the illustration.
w/ Smart Entry and Start System:
Disconnect the connector.
| 8. REMOVE FRONT PANEL GARNISH |
![]() |
Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.
| 9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.
| 10. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 bolts <B>.
w/o Driver Side Knee Airbag:
![]() |
Disengage the 5 clips and 3 guides to remove the instrument panel sub-assembly.
w/ Driver Side Knee Airbag:
![]() |
Disengage the 4 claws, 7 clips and 3 guides to remove the instrument panel sub-assembly.
| 11. REMOVE ROOM TEMPERATURE SENSOR (COOLER THERMISTOR) |
Disengage the 2 claws as shown in the illustration.
![]() |
Disconnect the cooler thermistor hose and connector and remove the room temperature sensor (cooler thermistor).