Home › Vehicle Interior › LIGHTING (INT) › FRONT DOOR COURTESY SWITCH

FRONT DOOR COURTESY SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT DOOR SCUFF PLATE


    B278977
  1. Disengage the 10 claws and remove the front door scuff plate LH.



2. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Disconnect the front door opening trim weatherstrip.



3. REMOVE REAR DOOR SCUFF PLATE


    B278979
  1. Disengage the 6 claws and remove the rear door scuff plate LH.

    HINT:
    Disengage the claws from the rear side of the scuff plate.



4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
  1. Disconnect the rear door opening trim weatherstrip.



5. REMOVE CENTER PILLAR LOWER GARNISH


    B278989
  1. Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.



6. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Disconnect the connector.



    E226718
  1. Using a T30 "TORX" socket wrench, remove the screw and front door courtesy light switch assembly.