Home › Engine / Hybrid System ยท 2AR-FE › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A085603E15
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

    NOTICE:
    Do not let adhesive adhere to the oil hole.

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour of installation.

  1. Connect the connector.



2. INSPECT FOR OIL LEAK


3. INSPECT ENGINE OIL LEVEL
  1. Warm up and stop the engine, and then wait 5 minutes.

  1. Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.
    If the level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill the engine with oil to above the full level mark.