Home › Engine / Hybrid System ยท 2AR-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE INTAKE VALVE


    A194956E01
  1. Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



2. REMOVE EXHAUST VALVE


    A194957E01
  1. Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE VALVE STEM OIL SEAL


    A194958
  1. Using needle-nose pliers, remove the oil seals.



4. REMOVE VALVE SPRING SEAT


    A194959
  1. Using compressed air and a Magnet Hand, remove the valve spring seat by blowing air onto it.



5. REMOVE NO. 1 STRAIGHT SCREW PLUG


A194960

NOTICE:
If water leaks from the No. 1 screw plug or the plug is corroded, replace it.

  1. Using a 10 mm hexagon wrench, remove the 3 screw plugs and 3 gaskets.



6. REMOVE NO. 2 STRAIGHT SCREW PLUG


A194961

NOTICE:
If water leaks from the No. 2 screw plug or the plug is corroded, replace it.

  1. Using a 14 mm hexagon wrench, remove the screw plug and gasket.



7. REMOVE STUD BOLT

NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.