Home › Engine / Hybrid System ยท 2AR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY



2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A195875E04
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-54015  
    09330-00021  
    91551-80650  



    A196849
  1. Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly, and rear drive plate spacer.



3. REMOVE REAR ENGINE OIL SEAL


    A195809E04
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or the crankshaft.